09-16-2019 03:54 AM
Good day all,
May someone please assist with IPSec Tunnels and Routing. Here's the scenario:
We have 2 RV110W routers on separate networks. They have separate modems providing internet access so essentially in separate locations. We have created an IPSec Tunnel and it's connected. Our current challenge is that we can ping the internet-facing side of the router but cannot ping the LAN side. Can someone assist with the static routing that is involved and if more information is required please feel free to ask for it and I will provide it.
Thank you.
Sydney
PS: this is my first Cisco Community post so I'm not very sure if I've articulated my problem correctly and if I've left out any crucial information.
09-16-2019 04:29 AM
Can you share your IP sec tunnel config here
09-17-2019 12:51 AM
Hi Junaid,
What would be the easiest way for me to do that?
Regards,
Sydney
09-16-2019 04:54 AM
Hello,
make sure to set the Networking > Routing --> Operating Mode to 'Gateway' (page 39 of the atached guide) or enable RIPng on both routers (page 40 of the attached guide)...
https://www.cisco.com/c/dam/en/us/td/docs/routers/csbr/rv110w/administration/guide/rv110w_admin.pdf
09-17-2019 12:50 AM
Hi Georg,
I followed your instructions but to no avail. I still can't ping LAN devices. I'm still able to ping the routers on their WAN ports but not LAN side.
Regards,
Sydney
09-17-2019 01:26 AM - edited 09-17-2019 01:29 AM
Hello,
can your LAN devices ping their own LAN and WAN ports ?
And can you post a screenshot of your settings in Step 4 and 5, page 101 of the admin guide ?
09-17-2019 01:34 AM
09-18-2019 12:20 AM
Hi Georg,
I think I may have found what my problem may be. While using packet tracer I recreated various scenarios and what I realized is that the WAN addresses have to be on the same subnet in order for this to work. Maybe I am wrong but that is how I got things to work.
Sydney.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide