IPSLA/RTR Command

[jpl861]

Hi Everybody,

I'm trying to do some testing with IP SLA and Enhanced Object Tracking and came up with a problem with the commands. I am using a 12.4(15)T7. From the track commands, I want to test the reachability of a host using "track 1 rtr 1 reachability" command. However, the rtr command isn't available now and it was already replaced by "ip sla" command. When I looked for "track 1 ip sla" command, it's not there, only track 1 ip route" is there.

My question is, will it work if I create a configuration like "ip sla 1" then apply it as "track 1 rtr 1"? Is that basically the same? Will the IOS treat the rtr as ip sla too? Thanks in advance.

John

[Giuseppe Larosa]

Hello John,

it looks like you should use the old syntax with rtr:

http://www.cisco.com/en/US/docs/ios/ipapp/configuration/guide/ipapp_eot_ps6350_TSD_Products_Configuration_Guide_Chapter.html#wp1055080

Effective with Cisco IOS Release 12.4(20)T the track rtr command was replaced by the track ip sla command.

Hope to help

Giuseppe