11-15-2015 09:23 AM - edited 03-05-2019 02:45 AM
Hello
Is there a way to prioritize by vlan on a SG300 switch? We're using latest firmware - 1.4.1.3 .
best regards, Rob Fantini
11-15-2015 11:36 AM
refer below docs to prioritize vlan traffic on sg300:
http://networking.bigresource.com/Cisco-Switches-how-to-configure-sg300-28-for-vlan-jgDx2JakR.html
-Do rate if it helps.
11-17-2015 07:23 AM
Hello .
First thank you for the response.. It was helpful however it led me to updated information in the manual.
per the Cisco 300 Series Admin. Guide 1.4.0 , page 562:
"VLAN Ingress Rate Limit
NOTE The VLAN Rate Limit feature is not available when the device is in Layer 3 mode."
So we are using Layer 3 mode
I guess that it is not possible to prioritise traffic by vlan tag?
Or is there a way to so in another configuration area?
best regards, Rob Fantini
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide