cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
732
Views
0
Helpful
7
Replies

ISDN BRI- Forcing b2 channel when B1 reaches its full capacity

Rachna Sharma
Beginner
Beginner

Hi

Can some one please advise.

I have a router running ISDN BRI connection, dial on demand (model 2811)

ISDN BRI has 2 channels, I am wanting to execute the command dialer load-threshold xxx either to use the second B channel if the first B channel reaches its full capacity. The confusion is with the rotary group? Can I not use this command without the rotary-group?  does the physical interface need to be configured as part of rotary group or the dialer interface? What is the use of rotary  group when already on ISDN I have 2 B channels.

 

BRI config:


interface BRI0/0/0
  bandwidth 64
 no ip address
 encapsulation ppp
 no ip mroute-cache
 dialer pool-member 1
 isdn switch-type basic-net3
 isdn point-to-point-setup
 ppp authentication chap
end

 

dialer interface config:


interface Dialer1
 bandwidth 64
 ip address x.x.x.x
 ip nat inside
 ip virtual-reassembly
 encapsulation ppp
 no ip mroute-cache
 ip ospf cost 30000
 dialer pool 1
 dialer remote-name abcdef
 dialer idle-timeout 300
 dialer string xxxxx
 dialer watch-group 30
 dialer-group 2
 no cdp enable
 ppp authentication chap
end

Regards,

 

1 Accepted Solution

Accepted Solutions

Georg Pauwen
VIP Master VIP Master
VIP Master

Hello,

 

as far as I recall, rotary groups are used for multiple physical BRI interfaces. In your case, with only one physical BRI, all you need is the two commands below:

 

ppp multilink
dialer load-threshold load [outbound | inbound | either]

View solution in original post

7 Replies 7

Georg Pauwen
VIP Master VIP Master
VIP Master

Hello,

 

as far as I recall, rotary groups are used for multiple physical BRI interfaces. In your case, with only one physical BRI, all you need is the two commands below:

 

ppp multilink
dialer load-threshold load [outbound | inbound | either]