Hi all,
I have a Cisco1751-V with 2 ISDN interface. I configure the system in mode network:
interface BRI0/0
no ip address
isdn switch-type basic-net3
isdn overlap-receiving
isdn protocol-emulate network
isdn layer1-emulate network
isdn incoming-voice voice
isdn skipsend-idverify
line-power
!
interface BRI0/1
no ip address
isdn switch-type basic-net3
isdn overlap-receiving
isdn protocol-emulate network
isdn layer1-emulate network
isdn incoming-voice voice
isdn skipsend-idverify
line-power
!
When I connect the cable, the state of layer 1 change to ACTIVE (and Layer 2 is TEI_ASSIGNED). When I disconnect the cable, the state of layer 1 is the same and not change to DEACTIVATED.
Then, if I type the command "clear interface bri 0/0", the state change to "DEACTIVATE"
Why not change automatically?