Urgent one for you. I have a requirement for a internet connection along with a customer. I have ordered a 50Mb connection and the ISP is providing a /28 or /29 for use.. Im going to require the use of a ptp VPN tunnel using a cisco RV082. I need to split off 10Mb for a customer who will also need to create a PTP VPN connection.
Please can you indicate how I can achieve this? Do I need to place another switch before my RV082 and have the customer buy their own device to manage the VPN or can we somehow utilise the same device and split of the connection from an inside switch?
I'm not familiar with the RV082 but in general you should police the traffic as close to the source as possible.
If you choose a centralized location such as the WAN router, then you will have to police based on ACL from the source.
BTW, QoS Policing is the feature you are after in order to limit the traffic to the bandwidth highlighted in your requirements.
Another piece of information is that you can't police outbound on a 3750 switch. You can only police inbound.
I'm not sure if the RV082 supports it but you can create subinterfaces facing the 3750 switch and each subinterface would have a service-policy with the limit set inbound from each customer. The 3750 switch would be configured as trunk facing the RV082.