Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey all,Need some help on the best way to configure rate limiting and/or traffic shaping for a single interface.Have a C3750-12S with an interface connected to a 10Mb circuit (leased line) 10Mb is shared over a 2 business units who respectively want...
Hi all,I know probably a very simple one however getting a little confused.I have a single switch stack comprising of 2 x c3750 connected via stackwise.Customer is connecting to it with 1 fiber connection currently and I have another ready to be plug...
Hi People,Can anyone help..I have a established VPN between NS500 and AS5505The following diagram shows whats going on.customer source subnet: 192.168.2.0/24Source NAT to 10.160.64.33NS500: sub int 1.3 : 10.160.64.1Destination NAT to : 199.53.28.17...
hey guys,Please help! I bought 3 refurbed c3750-12S to add to an existing switch in a stack. had version mismatch message so was able to tftp bin file from the master to 2 of the switches no problem.The 3rd didnt took the image and now is in a boot l...
Hey guys,I have 4 x cisco 3750g-12s in the following config attached diagram.Im running rpvst on all the switches and something seems to be incorrect with the config.As topology is in a loop providing redundancy from what i understand one port should...
I think the image is incorrect ? Im running c3750-ipbase-mz.122-35.SE5.bin on the other 2 (1 is actually ipservices and not base)if i use the following image do you think it will work?c3750-i5-mz.122-25.SE.bin
Thanks Edison.The RV082 doesnt support subinterfaces. Im going to have to go to a bigger piece of kit like the following I think :cisco 1805 integrated services router from looking at the product advisor..1: Is the diagram attached in my post the cor...
Hello Guys,Not sure why no responses to this one. Maybe in the wrong place?To reiterate..I have a datacenter ISP connection coming into my network shortly. (No internet connectivity at the moment)50Mb coming via a colocated ISPThe ISP have given me a...
What I mean is can I use the same standby addresses for each sub interface?eg:interface GigabitEthernet0/1 ip address 172.31.102.6 255.255.255.0 media-type sfp standby 1 ip 172.31.102.5 standby 1 timers 1 2 standby 1 priority 110 standby 1 preempt st...
Hi Richard,I dont want to route between the VLANS per se . Just for each to be able to reach the router..eg each VLAN is for a customer.vlan 1 = 10.115.11.0/28vlan 2 = 10.115.11.16/28etcCustomers need to connect to the router and access a server behi...
