Today I got a Cisco ISR1100 (C1111-8P) router.
Maybe I am doing something wrong here but I can't figure out how to enter the initial setup.
I am connecting with a mini usb cable to the console, when the router is booted I type enable and asks me for a password.
I have tried, cisco, password, password1, enablepass but none of these are correct.
I have tried to reset using the reset button and power button, after the reset it is in the same mode where I can't go into exec mode.
I have tried the reload command, and still no luck.
Is this oke?
no valid BOOT image found
Final autoboot attempt from default boot device...
Located c1100-universalk9_ias.16.08.01.SPA.bin
Console output boot:
Router>Rom image verified correctly
System Bootstrap, Version 16.6(1r), RELEASE SOFTWARE
Copyright (c) 1994-2017 by cisco Systems, Inc.
Current image running: Boot ROM0
Last reset cause: PowerOn
C1111-8P platform with 4194304 Kbytes of main memory
........
no valid BOOT image found
Final autoboot attempt from default boot device...
Located c1100-universalk9_ias.16.08.01.SPA.bin
################
Package header rev 3 structure detected
IsoSize = 386238464
Calculating SHA-1 hash...Validate package: SHA-1 hash:
calculated XXXXXXXX:XXXXXXXX:XXXXXXXX:XXXXXXXX:XXXXXXXX
expected XXXXXXXX:XXXXXXXX:XXXXXXXX:XXXXXXXX:XXXXXXXX
RSA Signed RELEASE Image Signature Verification Successful
Image validated
DXE 139 ms
BDS 456 ms
BDS 25 ms
Total Time = 620 ms
Cisco IOS Software [Fuji], ISR Software (ARMV8EB_LINUX_IOSD-UNIVERSALK9_IAS-M), Version 16.8.1, RELEASE SOFTWARE (fc3)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2018 by Cisco Systems, Inc.
Compiled Tue 27-Mar-18 10:56 by mcpre
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
Cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco IOS Software [Fuji], ISR Software (ARMV8EB_LINUX_IOSD-UNIVERSALK9_IAS-M), Version 16.8.1, RELEASE SOFTWARE (fc3)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2018 by Cisco Systems, Inc.
Compiled Tue 27-Mar-18 10:56 by mcpre
PLEASE READ THE FOLLOWING TERMS CAREFULLY. INSTALLING THE LICENSE OR
LICENSE KEY PROVIDED FOR ANY CISCO SOFTWARE PRODUCT, PRODUCT FEATURE,
AND/OR SUBSEQUENTLY PROVIDED SOFTWARE FEATURES (COLLECTIVELY, THE
"SOFTWARE"), AND/OR USING SUCH SOFTWARE CONSTITUTES YOUR FULL
ACCEPTANCE OF THE FOLLOWING TERMS. YOU MUST NOT PROCEED FURTHER IF YOU
ARE NOT WILLING TO BE BOUND BY ALL THE TERMS SET FORTH HEREIN.
Your use of the Software is subject to the Cisco End User License Agreement
(EULA) and any relevant supplemental terms (SEULA) found at
http://www.cisco.com/c/en/us/about/legal/cloud-and-software/software-terms.html.
You hereby acknowledge and agree that certain Software and/or features are
licensed for a particular term, that the license to such Software and/or
features is valid only for the applicable term and that such Software and/or
features may be shut down or otherwise terminated by Cisco after expiration
of the applicable license term (e.g., 90-day trial period). Cisco reserves
the right to terminate any such Software feature electronically or by any
other means available. While Cisco may provide alerts, it is your sole
responsibility to monitor your usage of any such term Software feature to
ensure that your systems and networks are prepared for a shutdown of the
Software feature.
cisco C1111-8P (1RU) processor with 1456982K/6147K bytes of memory.
Processor board ID XXXXXXXXXX
1 Virtual Ethernet interface
10 Gigabit Ethernet interfaces
32768K bytes of non-volatile configuration memory.
4194304K bytes of physical memory.
2863103K bytes of flash memory at bootflash:.
0K bytes of WebUI ODM Files at webui:.
%INIT: waited 0 seconds for NVRAM to be available
Press RETURN to get started!
CRYPTO_PKI: setting trustpoint policy for TP-self-signed-XXXXXXXXXX to specify TP-self-signed-XXXXXXXXXX keypair usage% Generating 2048 bit RSA keys, keys will be non-exportable...
[OK] (elapsed time was 0 seconds)
Router>
