Hello Geeks, I am preparing for CCNA reading Lammle's book I follow instruction on the book but cannot ping from Router A to Router C. See my Diagram . If am doing process with ipv4 is ok .
IPv6 is giving me problem. Here is configuration. Router B has two subnets int f0/0 is configured ipv6 address 2001:db8:3c4d:1::1/64 int f0/1 is configured ipv6 address 2001:db8:3c4d:2::1/64 Router A:i configured : Ipv6 address autoconfig
Router C used ipv6 address autoconfig This IPV6 I tried to ping from router A A#ping 2001:dB8:3C4D:2:201:42FF:FE27:5C02 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 2001:dB8:3C4D:2:201:42FF:FE27:5C02, timeout is 2 seconds: ..... Success rate is 0 percent (0/5)
This ipv6 tried to ping from Router C Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 2001:dB8:3C4D:1:2D0:BAFF:FEC7:2E01, timeout is 2 seconds: ..... Success rate is 0 percent (0/5) now ping int f0/1 of Router B is fine c#ping 2001:dB8:3C4D:2::1 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 2001:dB8:3C4D:2::1, timeout is 2 seconds: !!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 0/0/1 ms
Hello,We have a pair of N3K-3064PQ-10GX and one of them acting as backup and we want to migrate from VyOS to it, we want to add 500x interface vlan and each interface vlan has its own ip/prefixes (for example /30 /29 ...) and we ahve 6-8x BGP session with...
We live in an age that is both thrilling and evolving substantially. A new trend/technology is always on rise even before the preceding has been used to its fullest potential. Although the concepts of digital transformation may seem over discussed, ...
Show CommandPurposeCiscoICX-RuckusShow Spanning tree infoShow spanning-treeshow 802-1wVerify Port-Channel / Link aggregation infosh lag briefsh etherchannel summaryShow CDC/LDP neighbor infoshow cdp neighbors detailsh lldp neighbors de sh mac a...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.