layer 2 on ubr7246

[stephtchoko]

good day

i try to congure ubr7246 as bridge but the cable interface don't support the bridge group. i try tls over cable but for each cable modem ( client connect ) is mapped to different vlan, that avoid modem to get access on single vlan.

my objectiv is make access modem to single vlan:

somebody cahelp me to choose the best configuration to achieve this task ?

Any suggest ' ll be appreciated:

Regards:

[#2]

In an 802.1Q TLS setup, the cable modem of a specific customer is provisioned with the standard provisioning methods that are outlined by DOCSIS.Refer the following for more information

http://cisco.com/en/US/products/hw/cable/ps2217/products_configuration_example09186a008029160d.shtml#how_work