Legacy DDR

[alsayed]

Hi

i have a project, an client has only 2 Public IP addresses, i want to use Network address Translation (NAT)and we want to Use legacy DDR to connect to the ISP with PPP encapsulation.

How can i achieve a better config/Setup for this project?

who face like this setup plz provide necessary info...

10xs for ur help

[spremkumar]

Hi Sayed

You can configure something like Overload(PAT) to achieve your requirement.

You need to create inside and outside statements respectively.

Once you are done with the same do create an access-list permitting your local lan block to access any.

while creating the nat statement you need to make sure you are overloading onto the interface which connects you to the outside world..

also refer the below link for more info on the same..

http://www.cisco.com/en/US/tech/tk648/tk361/technologies_white_paper09186a0080091cb9.shtml

regds

[alsayed]

Hi spremkumar!

10xs for ur reply.but what about the connection to internet Thr ISDN

10XS

[rajivrajan1]

what is your connection type?

BRI/PRI and how you are dialing router to router or any numeber (to any RAS)?

[alsayed]

HI Mate!

we have BRI Interface and WE SHOULD lagacy DDR WITH Encap PPP

10XS

[alsayed]

Hi

any Help here regarding legacy DDR With ppp encap to ISP

10xs

[rajivrajan1]

http://www.cisco.com/en/US/tech/tk801/tk133/technologies_configuration_example09186a0080093c2e.shtml

http://www.cisco.com/en/US/products/sw/iosswrel/ps1826/products_configuration_guide_chapter09186a00800d9be1.html

[alsayed]

hi rajivrajan1

10xs for ur reply!