Got my CCNA PT 1 test passed and I'm hyped on Cisco!!!! Got my hands on a 2801 router and a DOCSIS 2.0 HWIC. I want to make sure the Comcast yahoos that are coming later this week just have to plug in and go. Thanks for any help in advance. Here's my runnning config:
burke-rtr#sh run
Building configuration...
Current configuration : 1673 bytes
!
version 15.1
service timestamps debug datetime msec
service timestamps log datetime msec
service password-encryption
!
hostname burke-rtr
!
boot-start-marker
boot-end-marker
!
!
enable password
!
no aaa new-model
!
dot11 syslog
no ip source-route
!
!
no ip dhcp use vrf connected
ip dhcp excluded-address 192.168.1.1 192.168.1.150
!
ip dhcp pool LAN
import all
network 192.168.1.0 255.255.255.0
default-router 192.168.1.1
dns-server 192.168.1.1
!
!
!
ip cef
no ip domain lookup
ip domain name comcast.net
ip name-server 68.87.71.226
ip name-server 75.75.75.75
ip name-server 75.75.76.76
!
multilink bundle-name authenticated
!
crypto pki token default removal timeout 0
!
!
!
!
archive
log config
hidekeys
!
redundancy
!
!
!
!
!
!
!
!
!
interface FastEthernet0/0
description LAN to WAN
ip address 192.168.1.2 255.255.255.0
ip nat inside
ip virtual-reassembly in
duplex auto
speed auto
no mop enabled
!
interface FastEthernet0/1
no ip address
shutdown
duplex auto
speed auto
!
interface Cable-Modem0/2/0
description Comcast-Link
ip address dhcp
no ip redirects
no ip unreachables
ip nbar protocol-discovery
ip nat outside
ip virtual-reassembly in
no shutdown
random-detect dscp-based
no cdp enable
!
ip forward-protocol nd
!
!
no ip http server
no ip http secure-server
ip nat inside source list 1 interface Cable-Modem0/2/0 overload
ip route 0.0.0.0 0.0.0.0 Cable-Modem0/2/0
!
access-list 1 permit 192.168.1.0 0.0.0.255
!
!
!
!
!
control-plane
!
!
!
line con 0
line aux 0
line vty 0 4
password
login
transport input all
!
scheduler allocate 20000 1000
end
***I don't know Comcast's DNS servers so I just put in what was on the website. Is my DHCP ok? Also on the cable interface, does everything look good? My local routing local traffic just fine, but that's to be expected. I saw some people put there lan interface into a VLAN. Do I need to do this. Again thank you! Also, when I do a sh int the mac address that comes up is 0000.0000.0000. Should I give them the MAC address on the card? obvisouly all the 0's is not valid. I thought the cable modems should two MACs, that's why I ask. Lastly the cable modem interface goes to an administrative shutdown state after I reload the router. Is this to be exepted? Thank you!
