12-27-2021 05:51 AM
Hello, I would like to set up the lisp protocol on a c3725 router under GNS3,
but the problem I cannot access in lisp configuration mode.
If I type the command router I cannot find the lisp mode.
I have installed several versions of router. Could you help me ? Thanks in advance.
Solved! Go to Solution.
01-04-2022 01:07 AM
Hi
I was playing around with lisp a little +15 years ago. I can't remember for shure, but I think I was using gns3. But I was using 7200 routers. Give them a try and see if they have support.
/Mikael
12-27-2021 02:37 PM
do you see in the documentation that this device supports LISP? generally only devices that support SD-WAN will support lisp, is my guess
12-28-2021 04:46 AM
Thanhs for your help.
12-27-2021 08:20 PM
Hello @you57 ,
LISP is too modern feature to be present on a C3725 that is a 15 years old router.
LISP is i used on:
EIGRP OTP Over the TOP
SD Access with DNAC
SD WAN
It requires IOS XE devices running at leat IOS XE 17.x code.
Hope to help
Giuseppe
12-28-2021 04:48 AM
thanks so much
01-04-2022 01:07 AM
Hi
I was playing around with lisp a little +15 years ago. I can't remember for shure, but I think I was using gns3. But I was using 7200 routers. Give them a try and see if they have support.
/Mikael
01-06-2022 11:56 AM
Hi,
yes 7200 have lisp. Thank you.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: