Load Balance 2 DSL - do not want mlppp

[anthonyfear]

Hi All

How do I configure router (2801) to load balance 2 adsl lines? I'm guessing I need 2 x dialer interfaces? and then I create 2 static routes? Is it as simple as that?

We have 2801 with 2 x dsl that we used to bond but ISP is pulling the bonded ADSL service due to problems. So I'll end up with 2 separate accounts instead. That's ok as we don't have high volume anyway. But how do I configure the router to load balance between the two connections?

Both connections will have separate account logins and separate public ip addresses.

Thanks in advance.

Anthony

[lgijssel]

There was another post on this today. There, the following link was given:

http://www.cisco.com/en/US/tech/tk648/tk361/technologies_configuration_example09186a00808d2b72.shtml#conf

Should give you a good start I presume!

regards,

Leo