Routing

Dear sir,I have configured bgp in my router. Here is my configuration.=======================router bgp 38031 bgp log-neighbor-changes network 203.112.72.0 network 203.112.73.0 network 203.112.74.0 network 203.112.75.0 network 203.112.76.0 network 20...

which technology is better for redundancy in switch HSRB or GLBP?

Hi everyone do i need to set timeout time on an inspection command and how long it should be set at?ip inspect name SDM cuseemeip inspect name SDM dnsip inspect name SDM ftpip inspect name SDM h323ip inspect name SDM icmpip inspect name SDM imapip in...

I Using Cisco 2811 router, i want to add another wan connection, what the difference between the "Hwic 4 esw" wic and "HWIC-1FE" wic?What is better solution? thanks.ron

Hi,Can anyone let me know what happen when there are two routes exist for same destination with same cost and AD and which route the device will install in it's routing table?For example ,I am having the below two routes,ip route 1.1.1.1 255.255.255....

Hi, Attached is the part of the config of my Cisco 877 router at a remote small office. It connects to a Cisco ASA at the HQ where all servers are kept.The VPN is working fine and I have been testing with the ACL on the 877 and realiased nothing I c...

Hi,I have a new Cisco 877 that works just fine for 20mins - 2hours but then fails and enters rommon mode for no reason. Then I can reset it and again it works for a while then goes back into rommon.Is this something that has been seen before?I would ...

Hi,How do i disable ping from internet on a Cisco 877? Thanks.

Hi AllHow do I configure router (2801) to load balance 2 adsl lines? I'm guessing I need 2 x dialer interfaces? and then I create 2 static routes? Is it as simple as that?We have 2801 with 2 x dsl that we used to bond but ISP is pulling the bonded AD...

Hi,we are terminating via L2TP our PPPoE users on a 7206vxr with npe-g1.Customers are then terminating these sessions in a VRF using Radius attributes.Now we are planning to introduce dynamic routing functionality: RIP,OSPF,BGP...Any info/experiences...

Hi,I am using 2821 router and trying to insert HWIC-1FE card. But the router is not picking the card. On show diag its saying "This card is not supported/ disabled". What can be the reason? please advice.

Hi,How can we make the router up when it goes down which is in remote location. can we make the router up remotely.

Hi,I have a 2811 (located in a central location) with NM HDV card and 5 Cisco AS5400 boxes in various locations. My aim is to monitor the VOIP call statistics of this 5 locations from the central location. I can configure IP SLA based RTP VOIP Operat...