Losing connection to PIX on 506-E

[m-jankowski]

When I access my PIX remotely or from the LAN it will drop the connection about 10 mins into configuring anything, even if I'm using the interface and monitoring. I then have to shut off my browser, wait a few minutes, then connect again. This is happening repeatably even with resets.

Any suggestions would be greatly appreciated.

[purohit_810]

Are you access by PDM or By Telnet ?

If PDM what is version no?

Regards,

Dharmesh Purohit

[m-jankowski]

Please refer to this topic as this thread was duplicated by mistake:

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=WAN%2C%20Routing%20and%20Switching&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.1ddf29b3

To answer, yes I am using PDM manager 3.0 on a PIX 506-E