03-07-2007 01:20 AM - edited 03-03-2019 04:03 PM
Hello
I have a point to point 2 Mbps connection on 1800 router. When i check the serial link status it show bandwith 1.54Mbps.
Can any one has an idea till what max. bandwidth is supported by WIC.? And what is the hardware for Bandwidth above maximum limit
03-07-2007 01:47 AM
Hello,
Please take look that this link:
http://www.cisco.com/en/US/products/hw/routers/ps274/products_tech_note09186a00800b0858.shtml
HTH,Please rate if it does.
-amit singh
03-14-2007 06:36 AM
It means that Each port support 8Mbps in synchronous mode.?
Does the use or not use of bandwidth command has any effect on the serial bandwidth
03-07-2007 04:20 AM
Hi Shoeb
1544Kbps is the default config under the serial interfaces and you can change the same using bandwidth command.
Also its nothing to do with the data communication/transfer which happens through the serial port.
regds
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide