MGX loopback

[trinawong]

Hi all,

Any good material for checking loopback in MGX?

Thanks,

[pkhatri]

What sort of information are you after ? Are you looking at doing physical loopbacks or software loopbacks ? What specific card are you interested in ?

Paresh

[trinawong]

Hi Paresh,

Thanks for your reply, I am looking for how to check software loop in MGX. Any good command reference?

Thanks,

[pkhatri]

Hi,

You can use the 'addlnloop' command to software-loop the line. Then, use 'dspln' command to verify that it has been set.

Hope that helps - pls rate the post if it does.

Paresh