MGX Problem

[trinawong]

Dear all,

When I applied command dspcon 20:1.3:3 1 1979

Port Vpi Vci Owner State Persistency

----------------------------------------------------------------------------

Local 20:1.3:3 1.1979 MASTER OK Persistent

Address: 55.003004030010100333609000.0000010b2d02.00

Node name: ftwotx90

Remote Routed <<< 1.447 SLAVE -- Persistent

Address: 55.003004030010100333602000.000001012d0b.00

Node name: ftwotx20

Can anyone advise what does Routed mean? why it not shows 'slot and port' number.

Thank You!

[mheusinger]

Hi,

this could refer to a SPVC routed by PNNI between two MGX Switches. If this seems unfeasable could you please provide more information about the network, MGX hw/sw and the like.

Regards, Martin

[albert.remo]

Hi!

Greetings!

Good day! Are you mapping your PVC statically or did you use PNNI? PNNI on ATM is like a routing protocol comparable to EIGRP in IP networks, so if you see this kinds of displays, it means that you have created a PVC that is dynamically routed through the ATM network by an ATM routing protocol.

Hope this helps,

Regards,,

Albert