Migrating Network Clock Commands from C2900 series to a ISR4351

[randyclark]

I am having an issue migrating the following commands from a 2900 to an ISR4351. I'm not that familiar with the clocking commands. Can someone provide an example of what I need to use on the ISR?

Routing, ISR 4000 Series

network-clock-participate wic 1

network-clock-select 1 T1 0/1/0

Not sure what to replace the wic 1 

network-clock participate ??

When I try to apply the following I get the G.781 message....

network-clock select 1 controller T1 0/1/0
G.781 based clock selection process is enabled Please unconfigure G.781 based configuration before configuring network-clock select config command

Best Regards,

[luis_cordova]

Hi @randyclark ,

Maybe this links can give you some guide:

https://learningnetwork.cisco.com/docs/DOC-21169

https://community.cisco.com/t5/ip-telephony-and-phones/network-clock-participate/td-p/1318350

Regards

[pieterh]

check if command below is present in your configuration

network-clock synchronization automatic

Enables the network clock selection algorithm. (Note that network clock synchronization is disabled by default.) Disables the Cisco-specific network clock process, and turns on the G.781-based automatic clock selection process.