Hi
I would like more information about this counter "rx_no_eop_err=4534" in sh controller serial
we have some error (CRC) in this interface and this counter increase.
sh controller serial 1/0
M4T: show controller:
PAS unit 0, subunit 0, f/w version 3-101, rev ID 0x2800001, version 3
idb = 0x63A26318, ds = 0x63A27AC0, ssb=0x63A27DFC
Clock mux=0x0, ucmd_ctrl=0xC, port_status=0x73
Serial config=0x8, line config=0x200
maxdgram=1608, bufpool=48Kb, 96 particles
DCD=up DSR=up DTR=up RTS=up CTS=up
line state: up
cable type : V.11 (X.21) DTE cable, received clockrate 1919292
base0 registers=0x3C800000, base1 registers=0x3C802000
mxt_ds=0x64502028, rx ring entries=47, tx ring entries=64
rxring=0xE350F00, rxr shadow=0x63A2E69C, rx_head=30
txring=0xE3510C0, txr shadow=0x63A2E908, tx_head=51, tx_tail=51, tx_count=0
throttled=0, enabled=0
halted=0, last halt reason=0
Microcode fatal errors=0
rx_no_eop_err=4534, rx_no_stp_err=0, rx_no_eop_stp_err=0
rx_no_buf=0, rx_soft_overrun_err=40, dump_err= 0, bogus=0, mxt_flags=0xC
tx_underrun_err=0, tx_soft_underrun_err=0, tx_limited=1(2)
tx_fullring=87616, tx_started=21483747
rx_int_count=21300225, tx_int_count=21736960
Half-duplex hdx=0x63A2E3E8, summary:-
invalid_state=0, jigged_sig=0, invalid_timeout=0, tx_drop=0
tx_int_err=0, rx_drop=0, timer_error=0, rts_timeout=0
invalid_rx=0, tx_lost_cts=0, cts_timeout=0, late_rx=0
SXDOP12#Connection closed by foreign host.