Routing

Hello,I have a NM-2CE1U= network module.S/N:26568717 and it seems that onecontroller on this network modul is malfunctioning. The line protocolon the interface is constantly in downstatus. I've tested already all thevariation of the port. I made a lo...

I am working as Technical supportHere is the situation .Two location A and BA side there are 2 tunnels build on Ethernet0/0in this 2 tunnels one tunnel is flapping frquently but the other tunnel is stable since a week .logs at A end router .Dec 6 23...

Hello members :)Strange thing. see:I wanted to route internet traffic from branch through dedicate router behind HQ router. For this reason I tried to implement route-map on HQ router's incomming serial interface, with ACL matching source adress of b...

I have a 2600XM router fitted with NM-2W. There is a wic in slot 0 and a VWIC2-2MFT-G.703 card in slot 1. I have configured both the ports on this card. One of the ports is working perfectly but when I connect a line to another port, it shows "Interf...

Hi guys/ ladies, I got a C2611, w/ 4 low speed serial ports. Can I use this single router to simulate a WAN cloud environment? If require DTE/DCE cables, how would I connect the cables? I just need a point-to-point non-broadcast.Pls advise.Thank you...

Hi allWe have two sites connecting with two 64Kseperate leased lines.I want to configure multilink these two lines.I dont want t0 use any routing protocols.Please tell me the configuration.Thanks in advanceSudeesh

we have three routers, mesh connected two of them has an ethernet interface and each interface is connected to a switch, the two switches must have the same IP subnet, how can we route traffic

Hello,I would like to know a bandwidtch utilization and trffic on my router 1751, it is possible ?Thank you.

Hi Experts,I am pretty confused about when and why do we need BGP. I have been thinking a lot about it, but my doubts couldnt get clear.1. I have a single connection to my ISP : I dont need BGP in this case as a signle static or defualt route can hel...

Please bear with me: I'm an old hand with Cisco, but I haven't really done any WAN work in about four years, so I've gotten rusty.I have a WAN scattered across about a dozen sites. There are about 100 users at the main site, 30 a what will be the se...

I would like to know if BERT should be performed on a non-looped T3 circuit and where do you look for the results?

Hi all, ok I've got a 3 2500 series routers attempting to setup sim WAN links over frame-relay. take a looka t this:Serial0 is up, line protocol is down Hardware is HD64570 Internet address is 192.168.40.2/24 MTU 1500 bytes, BW 1544 Kbit, DLY 200...

Looking for anyone with some stories (or nightmares) to tell regarding connecting remote offices. To date, we have done several but only to support communication between SRST and the call manager. Now, we are considering a remote office with approxim...

Hello all,I'm new to the forum and have a question about setting up a WAN using a 2507 and 2514 Cisco router. The two routers have a serial connection between them with the 2507 generating the clockrate at 250000 (DCE). I established an IP address fo...