cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
726
Views
0
Helpful
1
Replies

mpls xconnect limiting bandwidth

I have a two router cisco 2811 and channel is configured between them (mpls xconnect is UP). I perform the TCP test using JPerf, which occupies the entire band. The resulting bandwidth is 20 Mbit (mpls xconnect) and 15Mbit (l2tp). Can I set a limit on the speed channel for VPN? All routers are on the same corporate network ( mpls, ospf, ibgp)

1 Reply 1

Hello.

What type of PW do you use and where do you want to limit the bandwidth?

PS:typically you limit the amount of bandwidth with inbound policer, but I'm not sure if 2811 supports this.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco