03-10-2019 02:34 PM
Is there compatibility to create an MSDP group between Catalyst 6509 switches and N7K switches? Any restrictions? Has anyone done this and works fine?
03-10-2019 03:06 PM
MSDP works fine between 6500 and Nexus, i do not see any issue. (until you have any special case around the design)
here is the basic guide :
03-10-2019 03:55 PM
Hello,
I just tested the config below, and it works fine:
N7K
feature bgp
feature pim
feature msdp
!
ip route 2.2.2.2/32 192.168.1.2
ip pim ssm range 232.0.0.0/8
ip msdp peer 2.2.2.2 connect-source loopback1 remote-as 2
ip msdp mesh-group 2.2.2.2 MSDP
!
interface Ethernet2/1
no switchport
mac-address 0000.0000.002f
ip address 192.168.1.1/30
ip pim sparse-mode
no shutdown
!
interface loopback1
ip address 1.1.1.1/32
ip pim sparse-mode
!
router bgp 1
router-id 1.1.1.1
neighbor 192.168.1.2 remote-as 2
address-family ipv4 unicast
N7K#show ip msdp mesh-group
switch# sh ip msdp mesh-group
MSDP Mesh-Group Membership for VRF "default"
Mesh-group: MSDP
Peer: 2.2.2.2, AS: 2, description: none
IOS Switch
interface Loopback2
ip address 2.2.2.2 255.255.255.255
ip pim sparse-mode
!
interface GigabitEthernet0/0
no switchport
ip address 192.168.1.2 255.255.255.252
ip pim sparse-mode
negotiation auto
!
router bgp 2
bgp router-id 2.2.2.2
bgp log-neighbor-changes
neighbor 192.168.1.1 remote-as 1
!
address-family ipv4
neighbor 192.168.1.1 activate
exit-address-family
!
ip msdp peer 1.1.1.1
ip msdp cache-sa-state
ip msdp mesh-group MSDP 1.1.1.1
!
ip route 1.1.1.1 255.255.255.255 192.168.1.1
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide