05-09-2012 11:14 AM - edited 03-04-2019 04:18 PM
Dear Experts,
My client has router 2651 connected to internet via multiple ppp link. I am going to replace this router with ASR 1002 (RP1). ASR 1002 dont have any serial port, so I believe I have to replace multilink ppp configuration to PPPoE. I am having hardtime to find documents for PPPoE configuration on ASR 1002.
Thanks
05-09-2012 11:52 AM
The title of the question indicates that you are using multilink PPP which is used to combine several point to point serial links into one virtual interface. If the ASR does not have support for serial interfaces then you would need to replace the serial links with some kind of Ethernet. But I wonder why you think that you need to do PPPOE. I would think that a plain Ethernet (Fast or Gig Ethernet) would do what you want.
It was important to have PPP to combine several serial interfaces into one group. But when you switch to Ethernet I wonder why you would still need anything related to PPP?
HTH
Rick
05-09-2012 01:25 PM
HI Richard,
Thanks for reply. Yes, It was my misunderstanding. Now I come to know they have DS3 on ASR. In old router they have three serial link.
interface Multilinkabc
bandwidth 4608
ip address 1.2.3.4 255.255.255.252
ip access-group 1 in
ip route-cache flow
ntp disable
ppp multilink
ppp multilink fragment disable
ppp multilink links minimum 1
ppp multilink group abc
!
interface Serial0/0
bandwidth 1536
no ip address
encapsulation ppp
ip route-cache flow
no keepalive
no fair-queue
service-module t1 remote-alarm-enable
no cdp enable
ppp multilink
ppp multilink group abc
max-reserved-bandwidth 100
!
!
interface Serial0/1
bandwidth 1536
no ip address
encapsulation ppp
ip route-cache flow
service-module t1 remote-alarm-enable
no cdp enable
ppp multilink
ppp multilink group abc
max-reserved-bandwidth 100
!
interface Serial1/0
bandwidth 1536
no ip address
encapsulation ppp
ip route-cache flow
no fair-queue
service-module t1 remote-alarm-enable
no cdp enable
ppp multilink
ppp multilink group abc
max-reserved-bandwidth 100
So, what command should I use for T3 or DS3 configuration on IOS-XE ?
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide