Multiple ISP on sub interfaces, single Lan and PBR

[Mubeen]

Hi,

I'm trying to configure following scenario

Router: 3825 (with 2 ports)

Two ISP with different network address

One DHCP  

I terminated the ISP's in my 3750G switch on different vlans, made a trunk and connected it to router. Then I made access port in 3rd vlan and that vlan goes to Access switches and to Laptops / softphones.

I'm unable to still do that. not sure what I'm doing wrong

I have attached configs

[Georg Pauwen]

Hello,

how are you 'terminating' both ISP connections on the switch ? Post the full configuration of the 3750 switch and indicate which port is connected to which ISP. 

[Mubeen]

have attached configuration with first post. 

ISP 1: Vlan 100

ISP 2: Vlan 200

Trunk: Vlan 100 and 200

Access: Vlan 300

[Georg Pauwen]

Hello,

post the full config of the 3750 if possible...

[Deepak Kumar]

Hi,

Your configuration seems ok. Let me check for things

1. In the mentioned diagram, server Interface is looking down. Have you verified?

2. In the mentioned Diagram, The Either switch-1 is the basic Layer 2 switch. How terminated your server routing and connection on this switch?

3. Try to ping Server from the Router itself. Are you getting a reply from the server?

4. Start a server ping from the client and run a command on the router: "Show ip nat translation"

Regards,

Deepak Kumar