cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3180
Views
0
Helpful
6
Replies

Multiple Wan IP on a Single router fastethernet interface

mr.imranmohd
Level 1
Level 1

Hi,

My Scenario will be like this (Please see the attached image)

Cloud (ISP)

     |

Core Router

     |

Firewall

My Core Router Configuration as follows:

interface FastEthernet0/0

ip address 78.*.*.* 255.255.255.*

duplex auto

speed auto

!

interface FastEthernet0/1

description "Connection to ISP"

ip address 89.*.*.* 255.255.255.*

duplex auto

speed auto

!

Now We recently purchased the following Public ip as follows :

78.*.*.* (for router)

78.*.*.* (for Host)

My Question is where and how can i configure the new router public ip inorder to access the public host ip?

6 Replies 6

kcnajaf
Level 7
Level 7

HI Imran,

You could assign the new ip address as secondary ip address even though it is not a good practice to run the secondary ip address. Like

interface FastEthernet0/1

description "Connection to ISP"

ip address 89.*.*.* 255.255.255.*

ip address 78.*.*.* 255.255.255.* secondary

duplex auto

speed auto

Hope that helps.

Regards

Najaf

Please rate when applicable or helpful !!!

Dear Najaf,

Thaks for your support, i tried as you suggest; still its not working

#interface FastEthernet0/1

#ip address 89.*.*.* 255.255.255.*

#ip address 78.*.*.* 255.255.255.* secondary

#no shut

Even i tried the following but not working;

Primary_Router_HO(config)#inte fa0/1.1

Primary_Router_HO(config-subif)#ip address 78.*.*.* 255.255.255.*

% Configuring IP routing on a LAN subinterface is only allowed if that

subinterface is already configured as part of an IEEE 802.10, IEEE 802.1Q,

or ISL vLAN.

Primary_Router_HO(config-subif)#

Looking forward to your reply.

i have added the secondary ip to the fastethernet interface of my router

now i can ping this address from my lan

I have already added the Acl and Natting (for my local ip(10.10.3.5) to public ip)

But nothing is working.

I configured exactly same as old config; but unable to ping new public router ip as well as host ip..

u have to assing ip with /30 mask on your public interface.

*** Do Rate Helpful posts ***

Jawad

Hi,

Could you please share your configurations?

Regards

Najaf

I ask my provider to check the settings;

Anyhow now this is working without any changes.

Thanks for your valuable time and considerations.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: