Hi. I got hold of Version 15 - Page 3

Tommy Svensson · ‎11-24-2014

Hi.

I'm wondering about NAT loopback.

My problem is this:

I have 1 router Cisco 2911 that is the default gateway of the network. Then I have 1 web server and 1 PC on the internal network.

Router: 192.168.10.1

server: 192.168.10.20

PC: 192.168.10.10

the routers external IP is 10.0.0.1 /24

I have done the following: ip nat inside source static 192.168.10.20 10.0.0.10

I want my PC to be able to reach the web sites on the server through the "external address". Is that possible, to go out through the router and back in again?

Kind regards, Tommy

paul driver · ‎01-05-2015

Hello

Have you tried a different IOS yet?

res

Paul

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

Tommy Svensson · ‎01-07-2015

Hi.

I got hold of Version 15.4(2)T1 but I still have the same problem.

The NATed site is accessable on the NATed IP externally but not from the LAN.

I attached the config.

Kind regards, Tommy