Hello Everyone,
If I'm sitting inside my network (192.168.1.0/24) and I type in an internet browser my global address with a port attached (50.50.50.50:5001) it says page cannot be displayed, but if i'm outside of my network and I use that same address the port forwarding works? How do I configure my router to be able to use the global address when i'm inside my network so i do not have to change my server settings in all my devices everytime I want to check my work orders while sitting at my desk?
Config:
interface FastEthernet0/0
ip address 50.50.50.50 255.255.224.0
ip verify unicast source reachable-via rx allow-default 100
no ip redirects
no ip unreachables
no ip proxy-arp
ip nat outside
ip virtual-reassembly
speed 100
full-duplex
no keepalive
no mop enabled
!
interface FastEthernet0/1
ip address 192.168.1.1 255.255.255.0
no ip redirects
no ip unreachables
no ip proxy-arp
ip nat inside
ip virtual-reassembly
speed 100
full-duplex
no keepalive
no mop enabled
!
ip forward-protocol nd
ip route 0.0.0.0 0.0.0.0 50.50.50.x
!
!
ip nat inside source list 1 interface FastEthernet0/0 overload
ip nat inside source static tcp 192.168.1.10 5001 interface FastEthernet0/0 5001
ip nat inside source static tcp 192.168.1.10 5002 interface FastEthernet0/0 5002
!
!
access-list 1 permit 192.168.1.0 0.0.0.255
