04-04-2013 03:43 AM - edited 03-04-2019 07:29 PM
Hi
i'm having some cofussion that i have 2 internet connections and i want to use them as ACTIVE & STANDBY or both can load share at the same time with site to site vpn configuration
if i configure gateway of vlans on multilayer switch then how can i configure HSRP or if i do PBR then how it can be???????????
Devices:
cisco 881 router with 5mbps link
cisco 837 router with 2mbps link
cisco 3560x multilayer switch
Solved! Go to Solution.
04-04-2013 05:57 AM
Hi Salman,
Here is simple config for VPN backup on Head office:
crypto ipsec transform-set XX esp-3des esp-sha-hmac
crypto map MAP-A 100 ipsec-isakmp
set peer 2.2.2.2
set peer 1.1.1.1
set transform-set XX
match address vpn-to-branch
And on Branch you could configure HSRP on routers for failover.
Hope it will help.
Best regards,
Abzal
04-04-2013 05:35 AM
symbolic requirement plan is attached already above
can any one help me???????????????
04-04-2013 05:57 AM
Hi Salman,
Here is simple config for VPN backup on Head office:
crypto ipsec transform-set XX esp-3des esp-sha-hmac
crypto map MAP-A 100 ipsec-isakmp
set peer 2.2.2.2
set peer 1.1.1.1
set transform-set XX
match address vpn-to-branch
And on Branch you could configure HSRP on routers for failover.
Hope it will help.
Best regards,
Abzal
04-06-2013 02:20 AM
@abzal
thanx for reply
i'll do the same and if i found some more help i'll come back to u
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide