05-22-2006 05:02 PM - edited 03-03-2019 12:47 PM
This machine is giving me hard time. It does not load an image at boot up. All it can manage to do is take me into ROMMON. I have tried to download a new image from a tftp server but everything is not working out. I have tried to set environment variables like IP_ADDRESS and all the others but it is not doing me any good. Please help.....!!!
05-22-2006 10:10 PM
Hi,
tftp will not work in rommon.please check the config register and verify if IOS is not missing on flash by dir flash: command.if there's an IOS on the flash. you can issue: boot flash:(IOS).The switch should bootup if the IOS is not corrupted.if IOS is corrupted you download it using xmodem .refer to this link for more troubleshooting.
http://www.cisco.com/en/US/products/hw/switches/ps628/products_tech_note09186a0080169696.shtml
hope it helps..
05-24-2006 01:08 PM
Thank you zakymar77. Your message saved me a lot of pain. Every assistance you gave me was quite helpful and my switch now has loaded an IOS and is fully functioning.
Lots of thanks to you again.
Regards:
Mark-Anthony
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide