cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
388
Views
0
Helpful
1
Replies
Highlighted
Beginner

Network Analysis Module Configuration Problem

Hi,

I'm working on a network architecture as presented below :

PC1 -- Router 1 configured as Bridge -- Router 2 -- PC2

My Router 1 need to be configured as a bridge (the bridge is done between gi0/0 and gi0/1 by using a BVI interface).

Router 1 is 3825 with 12.4.15.T10

Router 2 is 2811 with 12.4.15.T10

Between PC1 and PC2, the ping is full OK


My problem :

I must install a NM-NAM Card in the Router 1 (bridged) to capture all traffic through my Router 1.

By studying Cisco site, I can't find my network configuration because I use a Router1 that is used as a bridge.

Is it possible to add my Network Analysis Module in the bridged Router1 and capture all traffic through it ?

Thanks a lot,

Best Regards,

Julien

Everyone's tags (5)
1 REPLY 1
Beginner

Re: Network Analysis Module Configuration Problem

I used this sheet : http://www.cisco.com/en/US/docs/routers/access/2600/software/notes/nm_nam.html#wp1052592

But nothing on router configured as bridge

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards