Routing

Hello everyone,This is an easy one for you guys , so I have this spare swicth sitting and I want to configure it to the exactly to one I have right now.Please tell me which should be the easiest and quickest way to do so ?For your convience I am atta...

Hi all,We are having some issue accesing, from our LAN, to a web server situated on the same internal network through our public address. We are trying to do so, since we use a program with a hyperlink to that web server and, we can use it making dem...

I am going to upgrade our 2821 wan router and am having difficulty in choosing the correct IOS. We are running spservices now and I would like to know the difference between SPSK9-SPSK9 Feature Set Factory Upgrade for Bundes versus just plain spservi...

Witam! Mam taki problem z VPN'em oraz backupem na ISDN. Skonfigurowałem VPN'a oraz backup na ISDN i tak:- VPN działa bez problemu ( backup niby także ) hosty z obydwóch sieci gdy jest ustanowione łącze VPN się pingują itd.- Jeżeli zrywam łączność VPN...

Dear All,any body do you know how to know feature IOS on Cisco product?i mean that if i have IOS as below, how can i know this feature?S184ASK9-12418Cisco 1841 IOS ADVANCED SECURITYif all of you know about Cisco router, switch and ASA please let me k...

Hi,I got one ASA 5520. We have 2 ISP's and each of them terminate in this ASA. Is it possible to do load balancing of general internet traffic in ASA 5520 so that some traffic go via ISP1 and remaining go via ISP2?  I am not really concerned about th...

hiI have a 3745 router that works as NAS network access server for PPPoE session and DSL clients the client authenticate to radius server VIA AAA protoclwe want to apply for every Authenticated clients a policy map that can mange thier speed we had t...

I have configured a 3G router 1841, connected to the service provider and got a public IP.But PC connected to Fa0/0 network cannot access the internet.Please advice how to get the internal network to access the Internet?I have added the default route...

Hi,Is there a way to catch packet size of a packet coming into an interface using an ACL. I don't need the exact packet size etc,  but packet above a certain MTU size may be blocked etc. so that i can see the counter increment.Victor.

Hi ,can we terminate MPLS VPN link on  a UTM.I have seen some UTM supporting Dynamic routing protocl /load balancing etc..kindly advise

A RV-082 dual-WAN router we installed cannot pull an IP address from the cable co.'s cable modem.  The WAN2 field stays at 0.0.0.0 even after repeated DHCP requests are issued, at the command of the web-based management page.  A laptop connected via ...

Hi all,My HQ site have intermittent connectivity problem to one of my overseas site. Eg, VPN connectivity to my overseas site face intermittent connectivity problems. I provide my isp(internet line for my HQ) the tracert from my HQ site to my oversea...

Hi All,firstly i do appologise for posting yet again with this, however i do seem to have got a little bit closer to the issue. I just dont seem to be able to fix it:(Here is the explanation .... At the Main Office we have a Cisco 2600 Router (IOS 12...

HiI have BGP /EIGRP failover for mutihome configured. I was expecting when the main link down the backup link will up immediately. can I put some ACL  on EIGRP to let the routers know only the special ip can update the route, not every equipments. ca...