02-20-2013 08:54 AM - edited 03-04-2019 07:05 PM
Do I create an SMTP Network Object and send TCP traffic throught NAT?
Or do I go to the ASDM's Configuration/Firewall, choose Public Servers, and choose Private Interface=inside, Public Interface=outside, set the private/public IPs, and choose SMTP as the service? This seems much simpler, but is it the correct way to do it?
I am using ASDM 6.4(5) and would like to use that versus the CLI.
Thanks!
02-20-2013 09:38 AM
Please Read this
http://www.cisco.com/en/US/products/ps6120/products_tech_note09186a0080b80d74.shtml
*** Do Rate all Helpful Posts ***
02-20-2013 09:39 AM
What is the version of your IOS on that ASA?
02-20-2013 05:25 PM
ASA is 8.2(5)
02-21-2013 09:50 AM
Ok in that case above mentioned link will work for you . Good luck.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide