08-22-2008 06:15 AM - edited 03-03-2019 11:14 PM
Hi there,
I've been working with my Cisco 800 Series router to try to allow access to an internal camera viewing server, and also a few IP cameras.
I have added the ip nat inside source static lines into the config, and also the permits to the access list.
Is there something I could have missed?
Outside address is 217.64.122.209
Internal IP addresses rqd are:
192.168.16.35
192.168.16.191
192.168.17.192
192.168.17.193
Many thanks I would appreciate any help
08-22-2008 06:32 AM
jaikaiman -
I would recommend blanking out your passwords and public IP address on this config.
The first thing I would do is move your access-lists from your ATM0 interface to your dialer interface. Your inbound access list also doesn't allow access to the public IP addresses for the camera, I think you may want to move the statements that reference the camera access from 106 to the 107 ACL.
08-22-2008 07:15 AM
Hi mlitka, thanks for replying so rapidly...
So, am I right in saying the atm0 should now read:
interface ATM0
no ip address
no ip access-group 107 in
no ip access-group 106 out
no ip redirects
and the ip access-group statements should be added to the dialer1 interface.
I understand the move of ip addresses from 106 to 107, but I do not understand in which part I change the inbound ACL to allow for the public ip addresses.
Many thanks again...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: