Routing

I'm sure this is possible but am unsure of what precisely i need to setup, maybe just RIP or EIGRP or ??? Basically I have 2 sites normally the WAN connection is a P2P T-1, both sites have their own internet and PIXs (506e so 6.x code) I want to setu...

On my 6509 with a SUP2/MFSC2 I am running IOS c6msfc2-jk2o3sv-mz.121-26.E1, this version of IOS does not support the Service-Policy Command on a Multi-Link PPP Interface, therefor causing me some QoS issues with VoIP.I have a 128Meg of DRAM on the MF...

We nned propose the Cisco 2821 router which support 16 Mbps ASAL link 0r more ADSL BW. Please suggest me the ADSL interface need to install in above router ?

we are on the process of configuring netflow on our cisco devices..one of them is 3750 and i just found a docu with matrix below;Table 1. NetFlow Recent Cisco Device Support MatrixDevice SupportedCisco 800, 1700, 2600 YesCisco 1800, 2800, 3800 Ye...

Dear All,I have a query regarding Auto-RP. As per my understanding we must configure sparse-dense mode on interfaces in case of Auto RP and if we don't want to configure Sparse-mode only then we have another option of configuring Auto-RP Listner so t...

Hi,I have 2 windows domains connected via site-to-site VPN. Both sites are using ios router 1811. Each site has a MS-exchange server. They need to exchange mails via esmtp. But the ip inspect smtp has dropped pkt.I have a link from microsoft explaini...

The customer router has a two ethernet connections to two routers with same ISP. All three run in same AS. The connecitivty is via BGP nothing else. The customer router is receiving a default route from both ISP routers. It is like a backup. One rout...

hello,is cisco 2811 supported on the netflow/nde config?thanks.

Hi,What is the use of getting an AS number from RIPE ( www.ripe.net )

Hi Guys,Do you have any software where i can view the traffic realtime, so as to see if anything changes during my configuration. I saw someone using this using SNMP.tnx

Hi Fellow Networkers,I was trying to block a BGP route with incomplete origin code(?) but got no luck.i tried route-map but there is no match statement for origin code, i also tried regular expression but still it didn,t work...Routers are connected ...

Hello,I'm starting a new thread, as the last one died out without resolve.I have Centurytel DSL service and the modem is in bridge mode, so the PPPoE login session gets passed through to the router. They assign us DHCP addresses (even for static - s...

Hi all. I have a cisco pix 515e where the internal ip is 192.168.1.254 and dmz ip is 192.168.2.254. I have a router which connects 192.168.1.0/24 subnet with the ip 192.168.1.253 and connects to 192.168.3.0/24 subnet. There is a server on my dmz with...