cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
241
Views
0
Helpful
2
Replies
raut.pawan
Beginner

Newtork design Suggestion

Hi Guys,

I have one question about Network design. We have two datacenter Primary and secondary.  we advertised same subnet from Primary and secondary  data center but from secondary DC we advertised these subnet with 2 times as prepend so the remote branches  which are connected via Service provider using BGP MPLS will always preferred Primary DC. But now we have requirement that one branch will always prefer secondary DC and other braches always prefer Primary DC. What we should do for it

2 REPLIES 2
Harish Balakrishnan
Enthusiast

Hello 

 

Since you are going through SP MPLS, you have lesser control on outbound route selection..Your traffic will always go to the PE where you have connected. I believe the easiest way to do this with the coordination with Service provider as they have better control for the advertised routes 

 

Harish.

Akash Agrawal
Cisco Employee

Hi,

 

You must have taken L3VPN service from service provider. On PE router service-provider needs to apply import route-map to increase LP of the preferred DC site.

 

Regards,

Akash