Routing

We have a fiber service provider and they have agreed to allow us to use an old Class C range that we have been sitting on for years.They said they can static route to us or we can use BGP with them. Our speed will be limited to 100Mbps for now but w...

Hello I currently have a single ISP which has also served as my DNS authoriative server. I am now moving to a Dual internet link using different providers. I am planning on building my own DNS servers. Until then, I need to use my cuurent DNS provide...

Hi All, Can any one let me know the answer for the below Question?If same route received through different LSA's. what will be the order of preference?

Hi Guys,I have one question about Network design. We have two datacenter Primary and secondary.  we advertised same subnet from Primary and secondary  data center but from secondary DC we advertised these subnet with 2 times as prepend so the remote ...

I have a lab with 4 routers connected in a square formation.   The two routers at the top of the "square" (R1 and R3) are not directly connected; they are connected through a Tunnel interface.  I'm running EIGRP in this topology and everything works ...

We have WAN transport that runs from Hawaii to SC (distance is approx 4700 miles) and rides two DISA MSPP circuits for the entire path between the sites.  We connect to a SONNET RING (15454 ONS) in SC to the final end point in the network.  The netwo...

This is the error log of a Cisco 1841 device :Syslog logging: enabled (0 messages dropped, 3 messages rate-limited,                0 flushes, 0 overruns, xml disabled, filtering disabled)No Active Message Discriminator. No Inactive Message Discrimina...

On a 2911 with a VWIC3-1MFT-T1/E1, is there a special configuration that I need to do to make it data-only?  We don't need voice yet, and all the configurations that I've seen as I read through hundreds of posts talk about configuring the card for vo...

Hi, I have a backup ADSL connection on a Cisco 1921 and have a block of 8 IPs from the my ISP. - Is it possibe to assign one of the static IPs to the LAN interface of the router, which will then connect to a different firewall/router to do NAT?, i.e....

Hallo,I have a cisco router and ASA. The internet link connects to the router first and then  to firewall. I have two internal web servers one of them is HTTPS and one is http. 192.168.11.112 is my HTTPS email server and currently it can be accessed ...