Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HI My Test ASA is dropping traffic coming via internet . ASA do not have any ACL configured on any interface but packet tracer showing it is dropping by ACL implicit Rule. Can someone let me know how its dropping and what is solution on it. (ASA co...
Hi , We have configured Dual-Active Detection with Fast-Hello but still we are seeing dual-active recovery mode: No Please suggest6509#sh switch virtual dual-active summPagp dual-active detection enabled: YesFast-hello dual-active detection enabled:...
Hi Guys,I have one question about Network design. We have two datacenter Primary and secondary. we advertised same subnet from Primary and secondary data center but from secondary DC we advertised these subnet with 2 times as prepend so the remote ...
Hi ,We have issue BGP neighborship With Service provider flapping 2-3 times in day. We have two BGP VPN VRF family configured and on same WAN ckt. BGP neighbor in one VRF family is stable more than 6 months but BGP neighbor in another VRF family is f...
Hi I am changing IOS of Cisco ASR 1001 from asr1001-universalk9.03.07.02.S.152-4.S2.binto asr1000rp1-adventerprisek9.03.04.02.S.151-3.S2.bin but everty time it boot up with old IOS universalk9. Is it becaused of Licence issue.Router#sh bootvarBOOT v...
You can configured etherchannel which provide redundancy as well as load sharing between two physical link.But only ISR 2811, 2821, 2851,3825, 3845 support ithttp://www.cisco.com/c/dam/en/us/products/collateral/routers/3800-series-integrated-services...
It look like either AP image from WLC was not able to downloaded correctly or was corruptedCan you take console and see the dir command that correct image file is downloaded in AP flash or not?
Please take note that Internet router should advetised default routes to ASA1 then only default-information originate inject default route into ospf process 100.Use network command and agg. network command in bgp on ASA1 router to advertised routes o...
