12-13-2017 07:29 AM - edited 03-05-2019 09:38 AM
Hello there,
On nexus 3064 I can do Q-in-Q with following config:
nterface g0/10
switchport
switchport mode dot1q-tunnel
switchport access vlan 222
but I don't know how to do many Q-in-Q incoming tunnels on one interface.
I receive VLAN 800-811 in Q-in-Q vlan 222
and VLAN 900-945 in Q-in-Q vlan 223
Is this passible on this switch ?
Thank you in advance !
Solved! Go to Solution.
12-14-2017 10:39 AM
I'm pretty sure it's not possible - I believe what you need is called selective q-in-q, which n3k cannot do.
12-14-2017 10:39 AM
I'm pretty sure it's not possible - I believe what you need is called selective q-in-q, which n3k cannot do.
12-14-2017 11:25 AM
12-15-2017 12:53 AM
12-14-2017 11:40 AM
Hello,
do you mean:
switchport vlan mapping 800-811 dot1q-tunnel 222
switchport vlan mapping 900-945 dot1q-tunnel 223
You need NX-OS 7.x for this command...
12-15-2017 02:09 AM
TPL(config-if)# switchport ?
<CR>
access Set access mode characteristics of the interface
autostate Include or exclude this port from vlan link up calculation
block Block specified outbound traffic for all VLANs
dot1q Configure dot1q EtherType value
host Set port host
isolated Disable loop-free detection.
mac-learn Disable/enable mac learning on interface
mode Enter the port mode
monitor Configures an interface as span-destination
private-vlan Set the private VLAN configuration
trunk Configure trunking parameters on an interface
TPL(config-if)#
TPL(config-if)# switchport vlan mapping 800-811 dot1q-tunnel 222
^
% Invalid command at '^' marker.
TPL(config-if)#
sh ver (ommited)
Software
BIOS: version 4.0.0
NXOS: version 7.0(3)I4(7)
BIOS compile time: 12/05/2016
NXOS image file is: bootflash:///nxos.7.0.3.I4.7.bin
NXOS compile time: 6/28/2017 14:00:00 [06/28/2017 21:53:29]
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide