03-20-2007
10:50 AM
- last edited on
03-25-2019
03:14 PM
by
ciscomoderator
I am trying to configure Auto QoS for VoIP on this switch module and it doesn't seem to work. It errors out applying the service policy in the outbound direction on the switchports. I have it installed in a 2811. Can anyone supply a sample QoS configuration for this switch network module that would effectively support directly attached Cisco phones?
03-26-2007 06:41 AM
Try this
conf t
mls qos
int fa0/0
switchport mode trunk
mls qos trust cos
mls qos device cisco-phone
no shut
03-26-2007 06:44 AM
What is the best practice when it comes to trusting CoS vs. DSCP?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide