Hello
There're more than twenty 6509VE running in the network. All of them has got 1GE or 10GE SFP / GBIC.
However, when I tried "show int trans" in some of them, there's nothing shown:
Router_A#sh int transceiv
No transceiver present
Router_A#sh inv
Router_A#sh int status | i connected
Gi1/1 connected 304 full 1000 1000BaseSX
Gi1/2 To WLC5508 connected trunk full 1000 1000BaseSX
Gi1/3 To WLC5508 connected trunk full 1000 1000BaseSX
Gi1/10 To WLC4404 connected trunk full 1000 1000BaseSX
Gi1/11 To WLC4404 connected trunk full 1000 1000BaseSX
Gi1/14 connected 961 full 1000 1000BaseSX
But from another 6509:
Router_B#sh int transceiver
Transceiver monitoring is disabled for all interfaces.
If device is externally calibrated, only calibrated values are printed.
++ : high alarm, + : high warning, - : low warning, -- : low alarm.
NA or N/A: not applicable, Tx: transmit, Rx: receive.
mA: milliamperes, dBm: decibels (milliwatts).
Optical Optical
Temperature Voltage Current Tx Power Rx Power
Port (Celsius) (Volts) (mA) (dBm) (dBm)
---------- ----------- ------- -------- -------- --------
Gi1/3 29.8 3.26 12.2 2.4 -15.2
Gi1/15 25.6 3.28 0.0 N/A N/A
Te5/4 34.0 0.00 7.9 -- -2.3 -2.3
Te5/5 28.7 0.00 0.0 N/A N/A
Te6/4 32.7 0.00 125.0 -- 1.4 -15.3
Te6/5 26.9 0.00 0.0 N/A N/A --
Pls help. Thanks!
