03-15-2011 07:40 AM - edited 03-04-2019 11:45 AM
OER Configuration & Trobleshooting
Hi all,
I would like to know how do we setup OER on a network having two routers connected to the Internet with two different ISP's. I would like to have one of these routers act as MC/BR and one to act as a BR.
I would also like to know on how do we configure load balancing and in case there is a latency or packet drop issue over the WAN how to configure to prefer the best path.
Kindly please provide me with some configuration examples.
Regards,
Harish
Solved! Go to Solution.
03-15-2011 07:47 AM
Please refer to this URL http://docwiki.cisco.com/wiki/PfR:Home
03-15-2011 07:47 AM
Please refer to this URL http://docwiki.cisco.com/wiki/PfR:Home
03-16-2011 01:14 AM
Hi Edison,
Thanks for the link. It was quite useful.
I would like to clear a few doubts. We have configured OER in our edge routers. When I see the sh oer master command, I see the following:
Learn Settings:
current state : SLEEP
time remaining in current state : 5428 seconds
no throughput
delay
no inside bgp
no protocol
monitor-period 5
periodic-interval 120
aggregation-type prefix-length 24
prefixes 100
expire after time 720
How will I come to know that the learn process is started. What does the above mean.
Regards,
Harish
03-17-2011 01:48 PM
Can you provide the configs?
Did you configure the key-chain at the Border Routers and Master Controller?
When linking the key-chain from BR to MC, did you verify the IP is reachable?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide