Ospf Distance

[ccobtn]

Hi,

On Ospf is it possible to increase cost/distance for specific external address type5/7, without increase all the external addressees as this can be done “distance ospf external xxx” .

I’m running Ospf and Rip with overlapping IP address hence I want to make router r3 to prefer routes from the Rip r4 for this specific address. This is so that all the request from user LAN to 10.net should via r4 and if the 10.Net is down, request is directed via r2. i have attached network diagram

Regards

[thisisshanky]

If the number of external routes are less, you could use the following command instead.

distance

Define the routes in the ACL which you want to apply the distance.

[ccobtn]

Hi,

What would be the src address "ip address to be suppressed"?. ACL "Standard or extended".

Regards