Packet Tracer Network Help.

[00u13yn8n4ZYTjCMN5d7]

I created the network above and I am trying to make an overloading nat to give internet (10.1.1.1) to all four computers.

I have tried:

Router(config)#int fa0/0
Router(config-if)#ip nat outside
Router(config)#int fa0/1
Router(config-if)#ip nat inside
Router(config)#access-list 16 permit 10.4.0.0 255.255.0.0
Router(config)#access-list 16 permit 10.2.0.0 255.255.0.0
Router(config)#access-list 16 permit 10.3.0.0 255.255.0.0
Router(config)#ip nat inside source list 16 int fa0/0 overload

Ive been going through different websites trying everything.

The nat translations I have is:

show ip nat translations
Pro  Inside global     Inside local       Outside local      Outside global
---  10.1.50.1         10.4.0.1           ---                ---

I'm stuck and any help is appreciated.

[Georg Pauwen]

Hello,

it looks like the masks on your access lists are reversed. Try the below, if that does not work, post the zipped Packet Tracer project (.pkt) file...

outer(config)#access-list 16 permit 10.4.0.0 0.0.255.255
Router(config)#access-list 16 permit 10.2.0.0 0.0.255.255
Router(config)#access-list 16 permit 10.3.0.0 0.0.255.255

[00u13yn8n4ZYTjCMN5d7]

I couldn't fix it with that so I have attached the file.

[paul driver]

Hello

Your topology was incorrect, it had misconfigured host and static addressing in any case as the rtr had a directly connected interface to the server nat wouldn't be applicable either, I have create two new PT files for you to review, The first shows a none NAT solution and the second shows one with NAT.