So I'm at a bit of a loss with this one. I've already configured it and had it working before, but decided to restart for fun. I typed up all of my actions beforehand, made some shoddy IP addressing tables in Word, and figured that was that. I go back to the base file, reconfigure everything and now it barely works. I don't have enough experience with PT to tell if it is being quirky or if I've missed something shamefully elementary whilst configuring the network.
The network is a WAN, with a 4 device fully-meshed L2 switched backbone, with network segment(s) coming off each to a rail station. Each of these network segments is within it's own OSPF area, and there is a static GRE tunnel route from one side of the network to the other. It's pretty self explanatory when you look at it.
What I've done:
- Configured OSPF on each area
- Configured OSPF on all router interfaces facing backbone (area 0)
- Configured tunnels on necessary routers and provided static route details
- Configured loopbacks for DR/BDR
- Configured switchport trunks and access ports as required
I'm not sure if it is allowed, but here is the link to my .pkt file:
https://drive.google.com/drive/folders/1EpGUm0XMGszdRBkxvJPOTUB1IIzcy7sb?usp=sharing
Would someone please be kind enough to have a look over it and give me some feedback on it? If the issue is a mistake on my part, please do not tell me the correct answer, just nudge (or throw) me in the right direction.