cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Join Customer Connection to register!
663
Views
10
Helpful
4
Replies
Joshua X P
Beginner

Packet tracer Site to site VPN configuration gone

Hi,

 

I configured Site to Site VPN in Packet tracer 7.3.0 between two 2901 routers. I Saved the running Conf to startup-config. But When turn OFF and turn ON the physical switch of the router my all VPN configurations are gone in the startup-config. If I reload the router using the Reload command, I'm not facing this issue. And I'm not facing this with 4321 routers.

 

I believe this could be a bug. Correct me If I'm wrong

 

Thanks,

Joshua X P

1 ACCEPTED SOLUTION

Accepted Solutions

Hello,

 

same here, so it seems to be a bug indeed. It seems to still be in the startup-config after the power down/up (sh startup-config). If you do a 'copy startup-config running-config' after the powe down/up, it should be back...

View solution in original post

4 REPLIES 4
Georg Pauwen
VIP Expert

Hello,

 

could be a bug indeed. Can you post the zipped .pkt file ?

Hi Georg,

Thanks for your reply!

 

Here I attached the Zipped .pkt file

 

Regards,

Joshua X P

Hello,

 

same here, so it seems to be a bug indeed. It seems to still be in the startup-config after the power down/up (sh startup-config). If you do a 'copy startup-config running-config' after the powe down/up, it should be back...

View solution in original post

Thanks for the solution! 

I hope Cisco would fix this bug in next update.