Hi,we have a FTD managed via FMC with 2 EIGRP Interfaces, one internal for Campus LAN and one DMZ to reach the DMVPN Hub routers for branch offices. We have EIGRP in place for dynamic routing. There is a site2site vpn configured on FMC and I would li...
I have been tasked to make a flat network across our data centers (East coast to West coast) I understand this is a bad ideal. I have two separate EVPL L2 links with two separate ISPs. In the name of redundancy I would like to create a port-channel...
I have minimal experience with routing and ios in general, so be kind.I have an ISR4331 CUBE.I want to use a pattern list URL for my voice class e164-pattern-map, and was wondering, is sftp supported? If so, how would I pass username and password? ...
I am not an expert in setting up ACLs, but I have a good understanding of the basics. However, I feel like I might be missing something.I have set up a new VLAN to provide direct internet access while blocking communication to other VLANs and on-prem...
Hello,I am trying to implement control plane policies on my test equipment, my cto is asking me to limit the ICMP max rate for all untrusted addresses. (I have to create an exception for knows hosts)Having very little experience in CoPP, I believed t...
I would like to know your thoughts on this lab.IP connectivity and OSPF are preconfigured on all devices where necessary. Do not make any changes to the IP addressing or OSPF. The company policy uses connected interfaces and next hops when configurin...
Hello, I've ran through this assignment about 20 times now word for word. No sure where i'm going wrong.
Could Destination Port Be VLAN in Port Mirroring on NCS5500? I saw failure messages as follows.Monitor-session xxxxDestination interface HundredGigE0/0/0/15.200Session has not been set up in the hardware===============================================...
I get this error after setting up a ipsec connection with my router and pfsense firewallICU4-ROUTER-01#show crypto isakmp saIPv4 Crypto ISAKMP SAdst src state conn-id status10.2.128.50 10.2.66.52 MM_NO_STATE 0 ACTIVE (deleted)IPv6 Crypto ISAKMP SA10....
I have a tunnel set up with a 10.22.32.1 address on one side, and 10.22.32.2 on the other. So, a GRE/IPsec tunnel, sharing some routes, and that part is fine. From the non-cisco side I can ping across the tunnel to the cicso, and if I traceroute, c...
hiwe're on Cisco IOS Software, C2960S Software (C2960S-UNIVERSALK9-M), Version 15.2(2a)E1, RELEASE SOFTWARE (fc1)Technical Support: http://www.cisco.com/techsupportCopyright (c) 1986-2014 by Cisco Systems, Inc.Compiled Wed 10-Dec-14 03:54 by prod_rel...
I deleted my OS image. The router is an old 2911. It does not boot (not a big surprise). I get stuck in ROMMAN mode. I would like to download a new OS image, but I have not been able to do. There are no more OS images on this box.There are 2 USB port...
hi,i bought a second hand 870 router, when i start the router it goes automatically to rommon. can someone help me out of this please. in advance thank you
Hi Guys, Please enlighten me what is the difference about the following about the OSPF. 1. "Network" command in OSPF process versus "IP OSPF" command in the interface level? 2. Which are the best practice? Thank you
I have a customer with cisco router has dual WAN and single LAN, customer required that dual WAN should work active/activeI changed the IP but the config is copy pasted, from below config the connection still going through ISP1 only, what should I ch...
