06-27-2009 04:43 AM - edited 03-04-2019 05:15 AM
I have just acquired and used 1811. I want to put the http traffic on FE1 and the other traffic on FE0.
One of the LAN ports will go to the ASA that will do the rest of the firewall and routing.
I need to setup policy based routing, but dont seem to find anything about this in the docs.
Can someone give me push in the right direction.
thank you!
06-27-2009 08:27 AM
06-27-2009 09:31 AM
I guess in this doc its there somewhere, but after reading it I didnt see where I can router http on one WAN and everything on the other. I did see lots of balancing and route on IP but nothing on the type of traffic. What is the set of commands that would do this?
06-27-2009 01:37 PM
Match port or equivalent ACL.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide