cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
183
Views
0
Helpful
1
Replies

Performance Management ?

sdawson35
Level 1
Level 1

                   Hi,

Apologies as I am not sure this is the correct place to post this question,

We have 2 office locations , One has two Cat 650x's and the other two Nexus 5k's, each device is connected via a seperate carriers

Site A                                                      Site_B

Switch_1a               carrier_X                        Switch_1b       

Switch_2a               carrier_Y                        Switch_2b  

No external routers involved as we are using L3 on the switches.

I need to be able to monitor and check bandwidth between the devices , however cannot find any tools for doing this (IPSLA would I think be ideal but no support for it on the 5k's)

Does anybody have any ideas ?, I should add that I would need to be able to either select source routing via ip address or interface so as to test each carrier similtaneously and compare results.

Regards

Scott.

1 Reply 1

Hello

I think NetFlow is applicable to your requirements- please review the link belwo

http://www.cisco.com/en/US/prod/collateral/iosswrel/ps6537/ps6555/ps6601/prod_white_paper0900aecd80406232.html

res

Paul

Please don't forget to rate any posts that have been helpful.

Thanks.


Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul
Review Cisco Networking products for a $25 gift card